Overview; I-I Overview; I-Ii Interswitch Setup - JRC JMA-5312-6 Instruction Manual

I
I-i

Overview

Interswitch NQE-3141 is equipment that enables free changeover between radar display units installed on
the bridge and antenna units having different characteristics.
If display unit is turned off or malfunctioned, the scanner unit can be controlled by other display unit.
If interswitch unit had malfunctioned, the radar system is switched to standalone mode.
Up to 8 units can be changed over.
When the connected scanner is changed, following setting values are automatically loaded.
Tune Adjustment
Bearing Adjustment
Range Adjustment
Antenna Height
Antenna installation location
Sector Blank
TNI Blank
Performance monitor adjustment
PRF Fine Tuning
I-ii Interswitch Setup
Connection modes can be changed simply by changing the interswitch connection (upper left of the display
⑥ on page 2-16).
Note: A master display unit is always necessary for establishing a slave connection.
Before a slave display unit can be placed in transmission state, the master display unit must be
placed in transmission state.
upper left of the display
The upper stand indicates the connected scanner unit.
If scanner unit name is not entered.
If scanner unit name is entered.
For How to names of scanner unit, see the "II-vi Names of display units and scanner units".
The lower stand indicates the connection mode.
Master :Mode in which the scanner unit can be controlled by the display unit.
Slave :Mode in which the scanner unit cannot be controlled.
When Slave is selected, transmission / standby and pulse length cannot be changed. The available
range is also limited.
OVERVIEW
(See the section 7.1.3)
(See the section 7.1.4)
(See the section 7.1.5)
(See the section 7.1.8)
(See the section 7.1.9)
(See the section 7.2.2)
(See the section 7.2.3)
(See the section 7.2.4)
(See the section 3.8.3)
:The scanner number is indicated.
:The scanner name is indicated (Max 6 characters).
A-1