JRC JMA-5312-6 Instruction Manual page 118

2
[II] Using Multi-dial
Procedures 1
2
Press numeric keys corresponding to the desired item number.
On and off functions of the item are switched.
On : Operation is conducted by the [MULTI] dial.
Off : Operation is not conducted by the [MULTI] dial.
Items set to On can be opened by pressing the [MULTI] dial.
Item overview
Vector Length
Trails Length
TT Display No.
C-Up Angle
Mark/Line Color
Manual Tune
Press the [MULTI] dial to select the parameter whose setting is to be
changed.
The multi-dial modes are switched.
Vector ⇒ Trails ⇒ TGT No. ⇒
⇒ Tune ⇒
Vector
The selected item is displayed in the multi-dial mode (lower left of the display on page
2-3).
For example, when three items, 1/2/3, are set to
multi-dial modes switch as shown below every time the [MULTI] dial is pressed.
Vector ⇒ Trails ⇒ TGT No. ⇒ Vector
Turn the [MULTI] dial to change the setting.
The preset values of the selected parameter will change sequentially.
Stop turning the dial when the desired value appears.
: The vector length of tracked target and activate AIS target is
adjusted.
: The radar trails length is adjusted.
: The target numbers of tracked target to be displayed are
switched.
: The course in the course up mode is adjusted.
: Mark / line colors are switched.
: Tune in the manual tune mode is adjusted.
3-21
Course ⇒ Mark ⇒
On at the initial setting, the