Teledyne 2105 Installation And Operation Manual page 49

Figure 2-36 Modbus configuration window
Figure 2-37 Device parameters (measured data)
Select the device's Modbus address, between 1 and 247. Enter a
connection retry interval in milliseconds (Request Timeout), and
the number of connection attempts before a connection failure is
determined.
Click Continue to open the Device Parameters window. From this
window, specify the parameter(s) measured by the device.
Enter a name for the parameter, and the number of the device's
register holding the data. The data format will depend on the
output of the connected device. The units of measure available in
the pull down list are determined by the data type you select.
2105 Interface Module
Section 2 Installation and Operation
Address between 1
and 247
List of added
parameters
2-31