Latches - Locking And Unlocking - Teledyne 2105 Installation And Operation Manual

2105 Interface Module
Section 2 Installation and Operation
2.2.1 Latches - Locking and
Unlocking
Figure 2-4 Unlocking the Latch
2-4
Follow the instructions below to install your 2105 module. Most
of these instructions are similar for the 2105
specific differences between the modules, they are identified.
Latches must be operated to stack and unstack the modules, and
to gain access to the vent screw. Take a moment to familiarize
yourself with operating the latches. The latch is normally locke,
but you must unlock the latch to place the module on top of
another module in a stack. The latch is unlocked by pushing in
the latch release on the connector side of the module. To lock the
latch, push in the latch on the desiccant side of the module.
The latch can be damaged by applying too much force. Never
press on both sides at the same time. Do not force the latch if it
is obstructed. While some degree of pressure must be applied
to slide the latch, the ends of the latches should never bend
1
more than / ".
8
Figure 2-4 shows how to unlock the latch.
i. Where there are
C
CAUTION