Section 2 Installation And Operation; Unpacking Instructions; 2105Ci Label Information; System Power - Teledyne 2105 Installation And Operation Manual

2105 Interface Module

Section 2 Installation and Operation

2.1 Unpacking
Instructions
Teledyne Isco
Customer Service Dept.
P.O. Box 82531
Lincoln, NE 68501 USA
Phone: (800) 228-4373
Outside USA & Canada call:
(402) 464-0231
FAX: (402) 465-3022
E-mail: IscoInfo@teledyne.com
2.1.1 2105Ci Label
Information
Figure 2-1 2105Ci serial label

2.1.2 System Power

When the system arrives, inspect the contents for any damage. If
there is damage, contact the delivery company and Teledyne Isco
(or its agent) immediately.
If there is any evidence that any items may have been
damaged in shipping, do not attempt to install the unit.
Please contact Teledyne Isco (or its agent) for advice.
When you unpack the system, check the items against the
packing list. If any parts are missing, contact the delivery
company and Teledyne Isco's Customer Service Department.
When you report missing part(s), please indicate them by part
number. In addition to the main packing list, there may be other
packing lists for various sub-components.
It is recommended that you retain the shipping cartons as they
can be used to ship the unit in the event that it is necessary to
transport the system.
Please complete the registration card and return it to Teledyne
Isco.
If you have a 2105Ci, you should record the IP address and phone
number printed on the label, found on the back of the unit
(Figure 2-1). You will need this information when you configure
the unit.
2105 modules can be powered by 7 to 26 volts. Some other 2100
system components are limited to a maximum of 16.6 volts
(12 volts typical). The voltage specification is printed on the
WARNING
2-1