Sonde Setup Tab; Sdi-12 Input - Teledyne 2105 Installation And Operation Manual

2105 Interface Module
Section 2 Installation and Operation

2.9 SDI-12 Input

Figure 2-25 Sonde setup tab
2-22
The 2105 connects to up to two SDI-12 sondes for measurement
of parameters such as conductivity, dissolved oxygen, etc.,
depending on how your system is configured. An interface cable
is available for connection to YSI sondes. All other sondes can be
connected using the universal interface cable. See Figure 2-38 for
cable information.
Scan for and activate or remove connected sondes using the
Sonde tab (Figure 2-25). To choose the parameters measured by
each sonde, highlight the sonde in the Active Sondes list and
click Configure.
To set up data storage for each parameter, use the Jump to mea-
surement tab pull down list.