Stacking Modules - Teledyne 2105 Installation And Operation Manual

2105 Interface Module
Section 2 Installation and Operation

2.3 Stacking Modules

Figure 2-10 Unlock latch and stow the cap
Figure 2-11 Aligning the modules
2-8
The 2105 can be located anywhere within a stack of up to four
2100 Series networked modules. It will draw its power from the
same source as the rest of the stack.
To connect the 2105 with another 2100 Series module:
1. On the top of the 2100 Series module, remove the cap and
stow it on the holder. This exposes the communication con-
nector on the module.
2. Inspect the module's communication connector. It should
be clean and dry. Damaged O-rings must be replaced.
3. If you are using the metal carrying handle, insert it
between the top two modules, with the handle turned
toward the rear of the stack (opposite the yellow labels).
4. Unlock the 2105's latch by pressing in on the latch release.
5. Underneath the 2105, remove the cap from the lower com-
munication connector and stow it in the holder.
6. Gently press the modules together and lock the 2105's
latch (desiccant side). The communications indicator will
blink during the start-up routine to indicate the 2105 is
operating.