Power Conservation (2105Ci) - Teledyne 2105 Installation And Operation Manual

2105 Interface Module
Section 2 Installation and Operation
2.7 Power Conservation
(2105Ci)
2-18
many as five. When an alarm condition is triggered, the
system will try dialing each number in the list.
a. To find a TAP number, and the communications param-
eter settings, consult with your pager service, or go to
http://avtech.com/Support/TAP/index.htm
http://www.notepage.net/tap-phone-numbers.htm
4. If you selected TAP, the phone number list area will be
slightly different. For each phone number entered, enter a
Pager ID, which is the phone number of the cell phone or
pager that will receive the text message. You can enter an
optional password of up to six characters in length. In the
Comm field, select 7E1 or 8N1 for the communications con-
trol specification (your pager service has this information).
5. You must enter a message to be sent to the pager. In the field
type the outgoing text message (maximum
labeled Message,
of 32 characters).
6. Under "Alarm condition," select the retry number and
interval, and define the alarm condition using the Equa-
tion Builder. Defined alarm conditions will appear on the
pull-down list.
7. Click the Apply button or press F9 when you are done, to
update the module's settings.
If you are using a 2105
power by setting up a Power Control method using the equation
builder. Rather than have the internal modem continuously
enabled, you can specify conditions for when it is powered up. To
begin configuring the power settings, click the Wireless Power
Control tab (Figure 2-21). Then click on Set Equation. (The Set
Wireless Schedule button is not selectable for any 2105 modules.)
Note
Power Control applies only to the internal modem, not the
module itself. However, during the specified periods when the
modem is disabled, you will only be able to communicate with
the module via direct connection.
i, you may want to conserve battery
C
or to