Setting Up Text Messaging (2105Ci); Setting Up Text Messaging And Alarm Conditions - Teledyne 2105 Installation And Operation Manual

2.6 Setting Up Text
Messaging (2105Ci)
Figure 2-20 Setting up text messaging and alarm conditions
If your cellular service is set up and ready for use through your
service provider, you can now connect to your interface module
via cellular connection.
Note
For systems using the cellular modem, a Power Control
method is highly recommended to conserve battery power.
Refer to Section 2.7.
The 2105Ci is capable of digital text messaging to up to 5 text
capable cellular phones or pagers when a programmed alarm
condition occurs. To program the 2105Ci for text messaging, you
must have the Short Message Service (SMS) or Telocator Alpha-
numeric Protocol (TAP) server number and parameter settings of
your cell phones and/or pagers.
1. Make sure you are connected to the site, and select the
Alarms tab (Figure 2-20).
2. Under Alarm Notification, select the Alarm type (SMS or
TAP). SMS is recommended. (The TAP option has been
retained for legacy systems; you may be unable to obtain a
number or service.)
3. In the Phone Number list box, type the contact telephone
numbers. These must be valid SMS or TAP access num-
bers. You must enter at least one number; you can enter as
2105 Interface Module
Section 2 Installation and Operation
2-17