Connecting To Flowlink - Teledyne 2105 Installation And Operation Manual

2105 Interface Module
Section 2 Installation and Operation
2.5 Connecting to
Flowlink
Figure 2-13 Flowlink connect screen (version 5.10.616)
2-10
Once the system is installed, you will configure it in a new or
existing site using Isco's Flowlink software.
Note
The 2105 and 2105Ci Modules require Flowlink 5.10.412a or
later.
The first time you connect to the site, you must connect your
computer directly to the stack using Isco's RS232 connect cable
( p a r t # 6 0 - 2 0 0 4 - 0 4 6 )
(part #60-2004-507). Open Flowlink and go to the Connect screen
(Figure 2-13) by either selecting it from the pull down menu or
clicking on the Quick Connect icon.
Make sure the connection Type is Direct, and click on the 2100
Instrument icon to connect. Upon initial connection, Flowlink
creates a site file and adds it to the database. If the system
detects the addition of a new module to an existing site, it will
display the Site Resolution screen (Figure 2-14). Otherwise, it
will display the Site Info screen (Figure 2-15).
o r U S B p o r t c o n n e c t c a b l e