Antenna (2105Ci Only) - Teledyne 2105 Installation And Operation Manual

2.4 Antenna (2105Ci Only)

Figure 2-12 Antenna connected to 2105Ci
The 2105Ci uses a magnetic mount antenna and Serial Over
Internet Protocol (SOIP) communication to connect with other
units. (The module is also capable of CSD communication, but
this service is being phased out. See Section 2.5.1 for complete
information.) Phone service with a static IP address, rather than
a land line, provides efficient communication.
Note
The 2105Ci only works in a CDMA cellular service area with
1xRTT. See your local CDMA service provider for availability.
As you face the unit, the 2105Ci antenna connector socket is
located on the right hand side of the module (Figure 2-12).
Remove the connector cap from the socket and attach it to the
cap on the end of the antenna cable. To connect the antenna,
press down on the silver metal latch on the side of the module
and push the antenna's connector into the socket.
Only use this antenna with 2100 Series Ci cellular modem
modules. Do not use this antenna with non-Ci equipment.
Note
For the transmitter to comply with FCC Maximum Permissible
Exposure (MPE) regulations, the antenna must be located a
minimum of 30 centimeters (12 inches) from the human body.
Note
When any communication connector is not in use, it should
always be capped. The cap will seal the connector to prevent
corrosion, prevent moisture from entering the unit, and improve
communications.
2105 Interface Module
Section 2 Installation and Operation
CAUTION
2-9