Communication Connectors - Teledyne 2105 Installation And Operation Manual

Figure 2-5 Locking the Latch
2.2.2 Communication
Connectors
Figure 2-5 shows how to lock the latch.
Latches will "click" when they are fully locked and unlocked.
When a communication connector is not in use, the con-
nector should always be capped. The cap will seal the con-
nector to prevent corrosion, prevent moisture from entering the
unit, and improve communications.
When a communication connector is in use, store the cap on the
holder next to the connector. The communication connector will
be sealed by its mating connector.
Caps PUSH ON and PULL OFF. Do not rotate the caps to
remove them from the connectors.
Note
For modules to correctly stack and lock together, protective
caps between the modules must be stored on the holders.
2105 Interface Module
Section 2 Installation and Operation
CAUTION
2-5