Setting Backup Data Reading/Writing; Error Codes For Operation U917 And U926 - Kyocera Fax System L Service Manual

Maintenance
item No.
U917

Setting backup data reading/writing

Description
Stores backup data from the fax control PCB into Compact Flash or reads the data from Compact Flash.
Purpose
To store and write data when replacing the PCB.
Setting
1. Turn the power switch off and disconnect the power plug.
2. Remove the shield cover.
3. Insert Compact Flash in a notch hole of the machine.
4. Turn on the power switch.
Connect the power plug while pressing the Copier key.
Press and hold on the Copier key until the message "Please wait." disappears.
5. Enter the maintenance item.
6. Press the start key. The screen for selecting an item is displayed.
7. Select the item using the up/down cursor keys. The selected item is displayed in reverse.
Display
SRAM→CF:BKUP
CF→SRAM:BKUP
SRAM→CF:DIAL
CF→SRAM:DIAL
8. Press the start key. Reading or writing is executed, and the screen displays the result.
• If the operation was successful:
EXECUTE 0100
CHECK SUM ∗∗∗∗
CODE 0000
• If the operation failed:
EXECUTE 0100
CHECK SUM ∗∗∗∗
CODE XXXX
Where XXX is the error code indicating the reason for the failure.
See "Error Codes for Operation U917 and U926" below.
9. Turn the power switch off and disconnect the power plug.
10. Remove the Compact Flash from the machine.

Error Codes for Operation U917 and U926

Code
0102
0104
0105
01FF
0202
0203
0204
0205
0206
0207
0212
Description
Writing the backup data of fax control PCB
Reading the backup data of fax control PCB
Writing the backup data of fax dial information
Reading the backup data of fax dial information
Detects call for service on fax control PCB.
Communication error.
Detects call for service on main PCB.
CF error.
No CF card.
No data in CF card.
CF data is incompatible.
Bad CF data (Checksum error)
CF read error.
CF write error.
Fax control PCB flash memory error.
Description
Meaning
3JF-2
1-3-37