Kyocera Fax System L Service Manual page 82

3JF
Contents
"The FAX is in use."
"FAX memory is full."
"The number of FAX transmission reservations
has reached maximum."
"The FAX cannot be used."
"The job has been interrupted at the FAX op-
eration panel."
Mail notification related
Transmission report is not delivered to clients.
1-5-4
Causes
Copying is being Retransmit after the cause described left is
performed. cleared.
Fax printing is being
performed.
Fax setting is being
performed.
Received originals
are being transmit-
ted.
Remote diagnosis is
being performed.
Printing interrupt
occurs during trans-
mission.
Network scanner is
being used.
Maintenance mode
is being performed.
Fax memory be- Secure memory area. (Delete data in the
came full while memory.)
transmission was Add memory.
performed. Retransmit with smaller resolution.
Divide originals to be transmitted.
NW-FAX transmis- After a while (after the number of the re-
sion was tried when served items is reduced), retransmit.
50 items of fax
transmission was
reserved.
The power switch is Turn on the power switch.
OFF when reception
into memory is set.
Fax is being reset. Retransmit after clearing reset.
The interrupt key Retransmit after interrupt was cleared.
was pressed while
transmission was
performed.
NW-FAX transmis- If the setting is OFF, no report is returned
sion of report output regardless of fax communication result. If a
in the fax initial set- special condition is set, a report is returned
ting is OFF or to be when a special event such as fax communi-
performed in a spe- cation error or broadcast transmission oc-
cial condition. curs. If a transmission report is needed, turn
the setting ON.
A client mail ad- Register the client mail address in the FAX
dress is not regis- Driver initial setting.
tered in the FAX
Driver.
A client mail ad- Check the client mail address.
dress registered in
the FAX Driver is
not correct.
Remarks
Corrective measures