Kyocera Fax System L Service Manual page 20

3JF
Turn the machine's power switch to OFF and unplug the machine from the power supply before installing the fax system.
<Procedure>
Install the optional Memory module DIMM (32MB).
1. Remove the two connectors of the fax control PCB assembly.
2. Remove the three screws and remove the mounting plate and the
ground wire.
3. Insert the memory module DIMM at an angle into the memory slot so that the notch of the memory DIMM is
positioned to the projection of the memory slot on the fax control PCB assembly. (1)
4. Push the free end of the module down toward the board. (2)
5. Attach the mounting plate and the ground wire that have been removed by Procedure 2 with the three screws to their
original positions.
6. Connect the two connectors that have been removed by Procedure 1.
Memory slot
1-2-2
Projection
Memory module DIMM
Fax control PCB assembly
Fax control PCB assembly
Ground wire
Notch
Figure 1-2-3
Screws
Mounting plate
Connectors
Figure 1-2-2
Memory slot
Memory module DIMM
Memory slot
Memory module DIMM