Kyocera Fax System L Service Manual page 25

22. Fit in the right-side two pawls of the operation section sheet cover
that has been removed by Procedure 20 and then attach the
operation section sheet cover to its original position.
Attach the one-touch securing sheet.
23. Remove the release paper from the one-touch securing sheet.
24. Adhere the one-touch securing sheet on the base frame of the one-touch key so that it sticks fast to the surface while
matching the top surface to the top left corner and firmly pressing the whole area down as shown in the illustration.
25. Push all the one-touch keys to check that the one-touch securing sheet does not block any one-touch key.
Attach the fax label (220-240 V specifications only).
26. Adhere the fax labels (1) to (4) of the fax label sheet of the
corresponding language at the positions for the cover plate shown
in the illustration.
One-touch securing sheet
Figure 1-2-17
Fax label sheet
Operation section sheet cover
Pawl
Pawl
Figure 1-2-16
Cover plate
Figure 1-2-18
3JF
1-2-7