Kyocera Fax System L Service Manual page 21

Remove the shield cover.
7. Remove the six screws, lift the shield cover and then remove the
cover.
Remove the modular cover.
8. Remove the screw and take off the modular cover.
Attach the fax control PCB assembly.
9. Loosen the screw on the printer board.
10. While taking care that the mounting surface of the board does not contact the frame section of the rear cover, insert
the U terminal of the ground wire of the fax control PCB assembly and secure it with the screw.
Frame section
Shield cover
Screw
Ground wire
Figure 1-2-6
Screws
Figure 1-2-4
Screw
Modular cover
Figure 1-2-5
Fax control PCB assembly
3JF
Screws
1-2-3