Setting The Mode For Remote Switching; Setting The Transmission Intervals; Setting The Loop Current Detection Before Dialing; Setting The Dis Signal To 4 Bytes - Kyocera Fax System L Service Manual

Maintenance
item No.
U607

Setting the mode for remote switching

(cont.) Sets the signal detection method for remote switching. Be sure to change the setting according to the type of
telephone connected to the machine.
1. Enter 1 or 2 using the numeric keys to change the setting.
Display
1: ONE
2: CONT
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.

Setting the transmission intervals

Sets the minimum time required for connection to the line for the next transmission after the previous
transmission was completed. Change the setting if transmission problems occur during multi-transmission,
such as broadcasting and polling transmission, or reserved transmission.
1. Change the setting using the numeric keys.
Display
1: 10
2: 30
3: 70
4: 120
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.

Setting the loop current detection before dialing

Sets if the loop current detection is performed before dialing.
1. Enter 1 or 2 using the numeric keys to change the setting.
Display
1: ON
2: OFF
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.

Setting the DIS signal to 4 bytes

Sets if bit 33 and later bits of the DIS/DTC signal are sent.
1. Enter 1 or 2 using the numeric keys to change the setting.
Display
1: ON
2: OFF
2. Press the start key. The value is set.
3. To return to the screen for selecting an item, press the stop/clear key.
Completion
Press the stop/clear key at the screen for selecting an item. The screen for selecting a maintenance item No. is
displayed.
One-shot detection
Continuous detection
Description
10 s
30 s
70 s
120 s
Performs loop current detection before dialing.
Does not perform loop current detection before dialing.
Bit 33 and later bits of the DIS/DTC signal are not sent.
Bit 33 and later bits of the DIS/DTC signal are sent.
Description
Description
Description
Description
3JF
1-3-13