Ending The Conference - Sony PCS-TL50 Operating Instructions Manual

When there is an incoming call during communication over a different line
interface
If you receive a call via an ISDN when you are in communication via a LAN
(or vice versa), the system becomes busy.
To display an elapsed communication time
You can show an elapsed communication time on the display if "Time
Display" in the General Setup menu is set to "On".
To turn the indicator off, set "Time Display" in the General Setup menu to
"Off". You can also turn off the indicator by selecting "Icon display OFF" in
the communication submenu during communication with a remote party.
For "Time Display" setting, see "General Setup Menu" on page 45.

Ending the Conference

1
Press the CONNECT/DISCONNECT (
Commander.
The message "Disconnect?" appears on the display.
2
Press the B or b button on the Remote Commander to select "OK", then
press the ENTER button, or press the CONNECT/DISCONNECT (
) button on the Remote Commander again.
The line is disconnected.
Note
The power of the system remains on even if the line is disconnected.
To cancel disconnection of the system
Select "Cancel" with the B or b button, then press the ENTER button.
To register the connected remote party in the Phone Book
You can easily register the remote party who has just disconnected.
If you set "Last Number Registration" in the General Setup menu to "On", the
message "Register this participant in the list?" appears after a conference with
an unregistered remote party is finished. When you select "OK", the Edit List
menu appears.
/ ) button on the Remote
Receiving a Call from a Remote Party
/
87