To connect to a computer via a hub
Connect the Video Communication System to a computer using the UTP
straight cable.
Computer
to LAN connector
To configure the Video Communication System
Open Page 2 of the General Setup menu, and enter the IP address of the
computer in which the NetMeeting application is installed in the "T.120 PC
Address" text box. (See page 45.)
To call a remote party to conduct a T.120 data conference
Set "T.120 Data" to "On" in Page 2 of the Dial Setup menu. (See page 41.)
When you receive a call from a remote party to conduct a T.120
data conference
Set "T.120 Data" to "On" in Page 2 of the Answer Setup menu. (See page 44.)
Note
It is recommended that you set "Audio Mode" to "G.728" in the Dial Setup and Answer
Setup menus.
To connect to a remote party using NetMeeting
Before connecting, install the NetMeeting application in your computer.
1
Double-click the NetMeeting icon, or click "NetMeeting" from the Start
menu on the computer's window.
NetMeeting starts.
2
Set the Video Communication System to communication mode.
Check that the "T.120" indicator appears on the display.
3
Click "Calling" in the NetMeeting window on the computer of either a
local or remote party.
Conducting a Data Conference Using NetMeeting – T.120 Data Conference
Hub
UTP straight cable (not supplied)
to 100BASE-TX/
10BASE-T
127