Sony PCS-TL50 Operating Instructions Manual page 138

Setting of "Monitor
Out (or Sub Monitor
Out)" on the receiving
terminal
When When
"Dual "Dual
Monitor" Monitor"
is set to is set to
"Off" "On"
RGB RGB
OUT OUT
(DSB) (DSB)
For the settings for output of the picture from each output connector, see the
Operating Instructions supplied with the PCS-1/1P.
When the PCS-11/11P is used as a receiving terminal
Resolution Video
frame
rate
a
a
138
Using Audio/Video Signal from the Connected Equipment for a Conference
Output Resolution
connector for a
computer
picture on
receiving
terminal
RGB OUT on
the PCSA-
DSB1S (only
when the
PCSA-DSB1S
is enabled)
Remarks
Outputs the signal by converting a transmitted VGA, SVGA or XGA
signal into a 4CIF signal. The original high-resolution picture cannot be
obtained and details cannot be clearly seen. The number of frames
displayed per second depends on the interface transmission rate. For
example, one frame per second is obtained at 1 Mbps.
Video Picture quality
frame
rate
Outputs the signal by
converting a transmitted
VGA, SVGA or XGA signal
into an XGA signal. The
high-resolution picture can
be obtained. You can view
more vivid picture than the
picture output from the RGB
OUT connector on the
Communication Terminal.
The number of frames
displayed per second
depends on the interface
transmission rates. For
example, five frames per
second are obtained at 1
Mbps.
Note
Three frames per second are
obtained for a transmitted
XGA signal.
a
: High,
a
: High,
f
: Middle, : Low
f
: Middle, : Low