Ending The Conference - Sony PCS-G70 Operating Instructions Manual

Ending the Conference

1
Press the CONNECT/DISCONNECT (
Commander.
The message "Disconnect?" appears on the monitor screen.
2
Press the B or b button on the Remote Commander to select "OK", then
press the PUSH ENTER button, or press the CONNECT/DISCONNECT
( /
The system is disconnected.
Note
The power of the Communication Terminal remains on even if the system is
disconnected.
To cancel disconnection of the system
Select "Cancel" with the B or b button, then press the PUSH ENTER button.
To register the connected remote party in the Phone Book
You can easily register the remote party who has just disconnected.
If you set "Last Number Registration" in the General Setup menu to "On", the
message "Register this participant in the list?" appears after a conference with
an unregistered remote party is finished. When you select "OK", the Edit List
menu appears.
Note
If the "Last Number Registration" is set to "Off", the message does not appear.
For "Last Number Registration" setting, see "Last Number Registration" on
page 54.
) button on the Remote Commander again.
/ ) button on the Remote
Receiving a Call from a Remote Party
89