Enroll Using Scan Access Points; Manually Configure Access Points - Honeywell L5210 Series Installation And Setup Manual

LYNX Touch Installation and Setup Guide
Programming the Control
SCREEN
WiFi Location
None

Enroll using Scan Access Points

Note: If the preferred access point is not available after scanning, manually select the network via the "Manually Configure
Access Points" procedure.
1. Select "Scan Access Points". The available networks and signal strength are displayed. Use the down
arrow to scroll to the next page of options. Use the
Ready To Arm
SSID = Vtek, RSSI = -62dbm
SSID = JimC, RSSI = -66dbm
SSID = Toms_net, RSSI = -86dbm
Edit Scan
2. Select the desired Network and then press the "Edit" button.
3. Select "Key" and enter the network password on the displayed keypad. The network information is displayed.
Select Done.
4. Select the "Join" button. A confirmation screen will be displayed.
5. Select "OK", then select "Save" to confirm the selection.
6. Select the " " button two times. The Ethernet information will be displayed. Signal strength will be indicated
by a series of colored bars along with the RSSI level (in dBM).
Bars
4 White
1 Yellow, 3 White
2 Yellow, 2 White
3 Yellow, 1 White
4 Yellow

Manually Configure Access Points

Note: For WEP Security type, the LYNX Touch supports the Key Index 1 in open system authentication mode.
1. Select "Manually Configure AP", the following screen is displayed.
Ready To Arm
Name SSID
Toms_net
Security
Network Type
WPA1 Infrastructure
Key
* * * *
Join Static
2. Select "SSID Name" and then enter a name (not to exceed 31 characters) on the displayed keyboard.
3. Select "Security". The system scrolls between the following options:
Open
WPA1
WPA2
WEP
When configuring for WEP encryption key on the access point, always use hexa-decimal type as the input method.
4. Select "Network Type". The system scrolls between "Infrastructure" and "Ad-Hoc".
2. Select "WiFi Location". The System will scroll between "None" and "Speaker Side". After
selecting "Speaker Side", the "Configure WiFi" option will be displayed.
3. Select "Configure WiFi". The following options will be displayed":
Scan Access Points
Manually Configure AP
WPS
5200-100-074-V0
Meaning
No connection
Weak
Fair
Good
Excellent
5200-100-076-V0
ACTION
arrow to return to the previous page.
RSSI range (dBM)
-255 (used internally)
-81 or higher
-71 to -80
-51 to -70
-50 or less
- 56 -