Introduction And Overview; Multiple Users; User Access Pin Code; System Arming - Honeywell Friedland GlobalGuard HISK1 Hardware Installation And Operating Manual

INTRODUCTION AND
OVERVIEW

MULTIPLE USERS

The system allows for up to 8 Users, a Master
(Admin) and 7 Users to be configured. This
allows the system Event Log to maintain a
record of which users have armed and disarmed
the system. Each user will have a different User
Access PIN Code.
Only the Admin User has access to the
programming functions and is able to configure
the system.

USER ACCESS PIN CODE

The Control Panel is the brains of the system
and is where the system is programmed and
operated from. A 4 digit PIN code is used to
ensure that only authorized people have access
to the system. This is the User access PIN code
and can be set to a code of your choice that only
you and other authorized system users know.

SYSTEM ARMING

The system has a 'Fully Arm', two 'Part-Arm'
and a 'Holiday Arm' modes. Fully Arm and
Holiday Arm will 'Arm' all zones while the 'Part-
Arm' modes will only arm the zones that are
enabled for the particular Part-Arm mode.
For example:
The system could be configured so that during
night time, 'Part-Arm-I' would arm only zones
protecting the lower floor and outbuildings
leaving the upper floor free for movement
without triggering the alarm.
During the day while the property is occupied
'Part-Arm-II' could arm only the zones protecting
the outbuildings. However, when the property is
left un-occupied, the 'Fully Arm' mode will arm
all zones to protect the entire property, (i.e.
upper and lower floors and outbuildings).
Fully & Holiday Arm
Part-Arm-I
Part-Arm-II

ENTRY/EXIT DELAY

When the system is armed with the Exit-Delay
enabled, no signal from any detector on an
active zone will be able to trigger an alarm until
the Exit-Delay has expired. This enables the
system to be armed from within the property and
allows time for the user to exit the property
without triggering an alarm. If the Exit-Delay is
disabled then detectors on active zones will
immediately be able to trigger an alarm once the
system is armed.
Zones1&2 only have been pre-configured
with an entry/exit delay of 30 seconds
because detectors added on these zones are
8