Device Timers; To Access Another Partition (Goto Command); Master Keypad Operation - Honeywell VISTA-128FBPT User Manual

System Overview (cont'd)

Device Timers

The system provides up to 20 "timers" that can be used to control various
devices, such as lights or appliances. These timers are similar in concept to
the individual appliance timers that might be purchased at a department
store. The devices that can be controlled are programmed into the system by
the installer. Up to 96 of these devices can be programmed. Refer to the
Programming Device Timers section for procedures.

To Access another Partition (GOTO Command)

Each keypad is assigned a default partition for display purposes, and will
show only that partition's information. But, if the user is authorized, a
keypad in one partition can be used to perform system functions in another
partition, by using the GOTO command. Note that only those partitions
authorized and programmed by the installer can be accessed in this manner.
To GOTO another partition, enter your security code, then press [ ∗ ∗ ∗ ∗ ] followed
by the desired partition number (1-8).
The keypad will remain in the new partition until directed to go to another
partition, or until 2 minutes has elapsed with no keypad activity. Entering
your security code, pressing [ ∗ ∗ ∗ ∗ ] followed by [0] will return the keypad to its
original partition.

Master Keypad Operation

A "Master" keypad is one on which the status of all eight partitions is
displayed simultaneously. A user can get more information about a certain
partition by simply entering [ ∗ ∗ ∗ ∗ ] + the desired partition number (1-8). To log
on to the "Master" partition (9) using the GOTO command, and to perform
any functions at a Master keypad, a user must have access to all partitions.
– 8 –
National Security Systems (800)457-1999
http://nationalsecuritysystems.com