Installing Ce Gas Drying Tumble Dryer; General Information - ALLIANCE 120 Series Installation, Operation & Maintenance Manual

Installation
Installing CE Gas Drying Tumble
Dryer

General Information

This information is to be used when installing gas
tumble dryers in countries and/or on gases different
than the machine's factory configuration. Tumble
dryers are supplied from the factory for operation on
Natural Gas 8914 kCal/m
3
Gas 22,250 kCal/m (2500 Btu/cu. ft.), with natural
gas group H/E, designation G20 and L.P. gas group
B/P, designation G30. To install machines in any other
country, or on any other gas, requires some level of
modification.
Machines are built in two different configurations:
 Natural Gas – regulated/governor
 Liquefied Petroleum (L.P.) Gas –
not regulated/no governor
Serial plates supplied from the factory are configured
for GB/IE/PT/ES/IT/GR/LU/CH/BE. These
instructions pertain to the situations when the country
of use or gas supply is different than that on the serial
plate.
26
3
(1000 Btu/cu. ft.), or L.P.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
These instructions are only valid if the following
country code is on the appliance: GB/IE/PT/ES/IT/
GR/LU/CH/BE. If this code is not present on the
appliance, it is necessary to refer to the technical
instructions which will provide the necessary
information concerning the modification of the
appliance to the condition of use for the country.
Before installation, check that the local distribution
conditions, nature of gas and pressure, and the
adjustment of the appliance are compatible.
Table 2 describes the different gases that are available
in different CE countries, and how the machines need
to be configured to operate with those gases. In the
CE, there are Natural Gas configurations that do not
allow for machine regulation and L.P. Gas
configurations that must be regulated. For L.P. Gas,
third family B/P at 50 mbar, order Regulated Natural
Gas machines and convert according to Table 2.
70458101 (EN)