Water Connections - ALLIANCE 120 Series Installation, Operation & Maintenance Manual

Installation
IMPORTANT: If temperature sensors inside the
tumble dryer register a temperature below 4.4°C
(40°F), the fire suppression system control will lock
out. This feature protects against operation of the
tumble dryer with a possible frozen water supply.
Only when the temperature sensors register a
temperature above 4.4°C (40°F) will the machine
reset for operation.
IMPORTANT: Flexible supply line/coupling must
be used. Solenoid valve failure due to hard
plumbing connections will void the warranty. It is
recommended that a filter or strainer be installed
in the water supply line.
1 Fire Suppression System Control Box
To connect the two hoses (supplied with tumble
dryer), insert rubber washers (from literature pack) in
water inlet hose couplings. Refer to Figure 4.
22
120 SERIES
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Water Connections

Two hoses and a Y-valve are provided with the tumble
dryer to allow for connection of water supply to
tumble dryer. The water connections are made to the
bushings of the water solenoid valve, located on the
rear of the tumble dryer. The Y-valve provides a single
female hose connection (Standard US 3/4-11 1/2 NH
thread). Refer to Figure 3 and Figure 4.
1
2
170 AND 200 SERIES
2 Water Solenoid Valve
Figure 3
5
4
1 Lock
2 Hose Couplings
3 Y Valve
4 Inlet Hoses
5 Opening for Auxiliary Alarm Cable
1
2
Figure 4
TMB2012N
2
3
TMB2008N
70458101 (EN)