Installation Safety Precautions - FUTABA T10PX Short Manual

Installation Safety Precautions

Warning
Receiver (receiver antenna)
Do not cut or bundle the receiver antenna wire.（R404SBS）
Do not bundle the receiver antenna wire together with the motor controller lead wire.（R404SBS）
Keep the receiver antenna at least 1 cm away from motor, battery, and other wiring carrying heavy current.
Do not use a metal receiver antenna holder on a plate made of metal, carbon, or other conductive mate-
rial.
Since the antenna of built-in antenna receivers is installed under this, do not place wiring or other objects
on it.
Battery
Antenna
Warning
Receiver Vibration-proofing / Waterproofing
(Car)
Vibration-proof the receiver by wrapping it in foam rubber or other vibration-absorbing material and
mount it with thick double-sided tape.
When using the receiver holder supplied with the model kit, mount the holder to the chassis through a
rubber grommet.
(Boat)
Vibration-proof the receiver by wrapping it in foam rubber or other vibration-absorbing material. Also wa-
terproof the receiver by cruising it in a plastic bag.
If the receiver is exposed to strong vibration and shock, or the ingression of water, it may not operate correctly and you may lose
control of the model.
Mechanical plate
When using the receiver holder supplied with the
kit, install the receiver through a rubber grommet.
Connector Connections
Be sure the receiver, servo, battery and connectors are fully and firmly connected.
If vibration from the model causes a connector to work loose while the model is in operation, you may lose control.
Servo Installation
When you install the servos, always use the rubber grommets provided in servo hardware bags. Mount the
servos so they do not directly come in contact with the mount.
If the servo case comes in direct contact with the mount, vibration will be directly transmitted to the servo.
If this condition continues for a long time, the servo may be damaged and control will be lost.
Install the receiver as far away as possible from the battery, motor controller, mo-
tor, silicon cord and other noise sources. Keep it away from the antenna wire, in
particular. The example in the figure is for R404SBS.
Since the antenna of built-in antenna receivers is installed
under this, do not place wiring or other objects on it.
Screw
Damper
Wrap the receiver in foam rubber or other vibration-ab-
sorbing material. Do not use hard material. Hard material
does not have a vibration-proofing effect.
Nut (as required)
Receiver holder
Mechanical plate
When mounting the receiver with double-sided tape, do not use
a stiff tape. Stiff tape does not have a vibration-proofing effect.
32
Foam rubber, etc.
Thick double-
sided tape