Appendix C - Using Serial Console - Fixstars GigaAccel 180 User Manual

Appendix C – Using Serial Console
The status check of GigaAccel 180 can be done by using the serial console
(minicom). To use the serial console, a serial cable is necessary.
* Skip Appendix B if the host doesn't use a Linux OS.
minicom is configured as follows.
# minicom –s
Serial port setup
A -
F - Hardware Flow Control : No
(Do not change other parameters)
Modem and dialing parameter setup
A - Init string ... (space)
B - Reset string ... (space)
C - Dialing prefix #1 ... (space)
D - Dialing suffix #1 ... (space)
E - Dialing prefix #2 ... (space)
F - Dialing suffix #2 ... (space)
G - Dialing prefix #3 ... (space)
H - Dialing suffix #3 ... (space)
I - Connect string ... (space)
J - No connect strings ... (space)
K - Hang-up string ... (space)
L - Dial cancel string ... (space)
(Do not change other parameters)
Save setup as dfl
Exit
After completing minicom configurations, start minicom.
# minicom
Serial Device
Copyright © Fixstars Corporation. All rights reserved.
: /dev/ttyS0
41