Start Up Pci Express; Stop Pci Express Driver; Reset Pci Express Driver - Fixstars GigaAccel 180 User Manual

When the installation succeeds, load modules.
# modprobe axon
# modprobe apnet
# lsmod | grep apnet
apnet xxxxx
axon xxxxx

7.3 Start up PCI Express

Start driver using the following command. Enter the following command on both
the host side and the GigaAccel 180 side.
# service pxcab start
To change the PCI Express driver IP address, edit the following file.
* The default IP addresses are set to "192.168.1.1" for the host and "192.168.1.2" for
GigaAccel 180.
# vi /etc/sysconfig/network-scripts/ifcfg-apnet0
Restart the driver if the IP address was changed.
# service pxcab restart

7.4 Stop PCI Express driver

Stop the PCI Express driver with the following command. (On both the host and
GigaAccel 180)
# service pxcab stop
[Note] If the driver was stopped on both the host and GigaAccel 180, then use the following
command on both the host and GigaAccel before starting the drivers again.
# modprobe axon
# modprobe apnet
# lsmod | grep apnet
apnet xxxxx
axon xxxxx

7.5 Reset PCI Express driver

Resetting the PCI Express driver will reboot GigaAccel 180.
* Perform this only on the host.
# service pxcab reset
0
1 apnet
0
1 apnet
Copyright © Fixstars Corporation. All rights reserved.
33