Restart Gigaaccel 180; Installation Of Yellow Dog Enterprise Linux - Fixstars GigaAccel 180 User Manual

Video accelerator card
Table of Contents

Advertisement

# vi /etc/xinetd.d/tftp
(setting value)
service tftp
{
disable = no ← change "yes" to "no"
(Do not change other parameters)
}
Restart xinetd after editing its configuration file.
# service xinetd restart

4.9 Restart GigaAccel 180

Restart GigaAccel 180 from the serial console (minicom). The serial baud rate is
115200. For serial console settings, please refer to "Appendix C – Using Serial
Console".
Start up the serial console.
# minicom
Pressing 's' while GigaAccel 180 is running will display the command prompt.
* When you configure the host machine, GigaAccel 180 may fail to boot. In this case,
press 'Enter' key and then the commad prompt is displayed.
Set the environment variables using the following command.
0 > setenv boot-file root=/dev/ram
Reboot GigaAccel 180.
0 > reboot
After the reboot is complete, Yellow Dog Enterprise Linux installer screen will be
displayed on screen.
* For the common console commands, please refer to "Appendix D – Common Console
Commands".

4.10 Installation of Yellow Dog Enterprise Linux

About installation of Yellow Dog Enterprise Linux, refer to URL
http://us.fixstars.com/support/solutions/ydel_6.x/ydel_configure_host_nohd.sh
tml.
Copyright © Fixstars Corporation. All rights reserved.
11

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GigaAccel 180 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents