(5) Connect serial port (9pin) that was left outside of the host machine. When
you use USB-serial conversion cable, please connect it to the usb port on the
host machine.
(6) Connect the Ethernet cable (crossover) to the eth0 port of GigaAccel 180.
The port will be used for network booting and NFS mounting. In the following
picture, the host machine has DHCP server, TFTP server and NFS server.
Copyright © Fixstars Corporation. All rights reserved.
Serial Connector(9pin)
GigaAccel 180 eth0
7
Host machine eth0