APRILIA RSV 1000 R FACTORY Workshop Manual page 270

RSV 1000 R - RSV 1000 R FACTORY
WARNING
The four brake pads must always be replaced to-
gether. Ensure they become properly seated in the
brake caliper.
•
Position the retaining clip (2).
•
Press the retaining clip (2) and insert the pin (3) from the
inside.
•
Release the retaining clip (2) and ensure it becomes
securely engaged with the pin (3).
DANGER
When released, the retaining clip (2) should become
correctly located into its seats to lock the pin (3) in
place.
When the clip is positioned correctly, the pin (3) will
not come off. Try to extract the pin to ensure clip
and pin are securely in place.
•
Position the front brake caliper on the brake disc.
• Tighten the two bolts (1) fully until finger tight.
•
Operate the front brake lever. This will help the brake caliper
become properly seated.
• Keep the brake squeezed in and tighten the two bolts (1).
•
Check the front brake fluid level.
CYCLE PARTS
5 - 125