APRILIA RSV 1000 R FACTORY Workshop Manual page 269

CYCLE PARTS
5.8.2. CHANGING THE FRONT BRAKE PADS
(RSV FACT)
TORQUE WRENCH SETTINGS
Brake caliper bolts (1)
WARNING
This vehicle is equipped with a twin-disc front brake
(one disc on
Always change all brake pads of both front brake
calipers as a set.
Changing the brake pads of one front brake caliper
only will affect the stability and safety of the vehicle,
putting the safety of persons or property at risk or
leading to vehicle damage.
NOTE The following procedure applies to both brake calipers.
•
Release and remove the two caliper mounting bolts (1).
•
Extract the front brake caliper from the disc.
•
Press the retaining clip (2) and extract the pin (3) from the
inside.
•
Remove the retaining clip (2).
• Extract both pads (4).
WARNING
Do not operate the brake lever with the brake pads
removed, or the brake caliper pistons might fall out
leading to loss of brake fluid.
•
Fit new brake pads and ensure they become properly seated
in the caliper.
5 - 124
36.87 ftlb (50 Nm)
either side of the
RSV 1000 R - RSV 1000 R FACTORY
wheel).