Federal Communications Commission
Radio Frequency Interference Statement
The
equipment
described
in this manual generates
and
uses
radio frequency
energy. If
it is not installed
and
llsed properly
(i.e.
in
strict accordance with these
instructions),
it may cause interference
to radio
or
television
reception.
FCC I.D.
Number:
EY5QGAUDANIMATOR
This
equipment
has been
type tested and found
to comply
with
the limits
for a
class
B computing
device
in accordance with
the
specifications
in
Subpart J of
Part 15
of
the FCC
Rules.
These rules
are
designed to provide reasonable
protection
against
radio
and television
interference in residential installation.
However, there is no
guarantee
that interference will not
occur
in a particular
installation. If this
equipment
does cause interference to
radio
or television
equipment
off and
on,
the user
is encouraged
to try
to
correct the interference by
one
or more of the
following
measures:
o
Reposition
the receiver's antenna.
Also
make
sure
the
antenna
wires
are making
good
electrical contact.
o
Use a roof-mounted antenna
rather
than a "rabbit-ear"
antenna
or
an antenna
mounted
in the attic.
o
Make sure that all electrical connections on
the
computer
are secure and any shielded
I/O
cables that
are required
for
compliance are properly fastened.
o
Move the
computer
farther
away from
the receiver.
o
Plug the computer
and
receiver into
separate
electrical
circuits.
If necessary,
the
user
should consult the dealer or an experienced
radio/television
technician
for additional suggestions.
The
user
may
find
the
following booklet
prepared
by the
Federal
Communications Commission
helpful:
"How
to Identify
and
Solve Radio-TV Interference
Problems"
This booklet is
available from
the U.S.
Government Printing
Office,
Washington,
D.C. 240402, Stock No. 004-000-00345-4.
Note:
This equipment has
been
certified
to
comply
with the limits for Class B
computing device, pursuant
to
Subpart]
of Part
15
of FCC
Rules. Only
peripherals (computer input/output devices,
keyboards,
terminals, printers,
etc.)
certified to
comply
with
the
Class B limits may be attached to this computer.
O
peration with non-certified
peripherals
is likely to result in interference to
radio
and TV reception.
Finally,
any
unauthorized
changes
or modifications not
expressly
approved by
the manufacturer could void the user's authority to operate the equipment.
[
{
{
Need help?
Do you have a question about the AUDIO ANIMATOR and is the answer not in the manual?