Applied Engineering AUDIO ANIMATOR User Manual page 100

An example of clipped sound
Playback Sample Rate plays much slower than recorded
If you have a TransWarp GS, you need to turn On the
AppleTalk/IRQ option from the TransWarp's Configure
menu.
Pasted segment plays slower/faster than main file
If you're pasting segments from one file to another, you need
to make sure the files were recorded at the same rate. To
record a new file at the same rate as an existing file, use the
Set Record to Play Rate option in the Setup menu while the
existing file is active, then record the new file .
Other sound programs do not play AA file correctly
Use the Save As command ro save the AA files as either Raw
Data or AIFF files. If the sound program you're using doesn't
allow you to change the playback rate, set the Record Sample
Rate to the necessary setting before recording.
Sound file plays but no wave displayed
If you do not see the sound wave even though you can hear
the sound, it may be because you recorded a mono input in
stereo. Try displaying the other channel (from the Setup
menu).
You may also be zoomed in on a small portion of the file .
Choose Full View (O-F) from the View menu.
Audio Animator's Error Messages
Cannot Set Record to Playback
The maximum
Playback Sample Rate
is higher than the
maximum
Record Sample Rate
so the record cannot always
be set equal to the playback rate. For example, if your
Playback Sample Rate
is set to 43382, th e
Reco r d Sample
Rate
cannot match that setting.
e6 App. B - Trouble Shooting
r
r