Table of Contents
Advertisement
3 .
P R O J E C T O R I N S T AL L AT I O N AN D
AS S E M B L Y
3.1.
U
N P AC K I N G TH E
Before opening box(es), carefully inspect outside of carton(s). If carton
has been damaged, notify shipper immediately; do not open carton
unless instructed to do so.
The CHRISTIE P35GPS projector may be shipped in more than one container. Each
P35GPS projector normally comes complete with the following items:
• dual aperture plate (shipped in place)
•
framing lamp (installed)
•
soundhead flywheel (not installed)
•
soundhead assembly (factory-aligned)
•
dual-lens turret
• drive motor assembly
• instruction manual.
The console and projector are shipped in a single carton, with special pockets containing
smaller items. The lens turret and soundhead flywheel are shipped separately.
To unpack:
1. Open carton(s).
2. Remove all protective material from framing lamp, soundhead assembly, and lens holder.
3. Remove protective material around side panel.
3.2.
I
N S TAL L ATI O N
To install the projector, refer to
and assembling the P35GPS projector are outlined in the Table in
1. Loosen but do not remove nut on projector mounting stud (item 4 in
that lock washer (item 5 in
positioned on mounting stud. Flat washer should be next to lock washer, followed by nut.
CHRISTIE INCORPORATED P35GPS Projector
June, 1998
P
R O J E C TO R
Figure
3-1. The required materials and tools for installing
Figure
3-1) and flat washer (item 6 in
3
Figure 3-2.
Figure
3-1). Verify
Figure
3-1) are correctly
3-1
Advertisement
Table of Contents
