Table of Contents
Advertisement
9. Adjust LED power supply output for 4 ±0.5V of video amplitude if necessary.
10. Lock all adjustment set screws (items 3, 4, 7, and 9 in
6.3.
D
AS H P O T
1. Turn hex-slotted screw counter clockwise at bottom of dashpot assembly through access
hole in projector bottom plate, until friction of dashpot is at lowest point.
2. Run wow and flutter test film and increase friction by turning hex slotted screw, at
bottom of dashpot assembly, clockwise until best result is obtained.
6.4.
I
, O
N N E R
NEVER adjust belts with power applied!
WARNING
Belt tension should be kept as loose as possible while remaining tight enough to drive all
mechanisms. To adjust belt tension, follow procedures in
Do not over-tighten belts. If belts are too tight, projector will not
operate properly, and projector parts will wear prematurely.
6 . 4 . 1 . I
T
N N E R
I M I N G
Refer to
Figure 5-3
1. Loosen inner timing belt pulley locking screw (item 1 in
2. Adjust inner timing belt pulley until belt deflection is 0.25 inch (item 10 in
Belt should be just tight enough to prevent slapping.
3. Tighten locking screw (item 1 in
6 . 4 . 2 . S
H U T T E R
Refer to
Figure 5-4
1. Loosen three screws securing adjust plate (item 5 in
2. Pull adjust plate (item 5 in
just possible to touch belt together at its midpoint.
3. Tighten screws firmly.
CHRISTIE INCORPORATED P35GPS Projector
June, 1998
6 : C a l i b r a t i o n , A l i g n m e n t , a n d A d j u s t m e n t P r o c e d u r e s
A
D J U S TM E N T
,
S
U TE R
AN D
H U TTE R
B
E L T
on page 5-4.
Figure
T
B
I M I N G
E L T
on page 5-5.
Figure
5-4) up until belt deflection is 0.25 inch. It should be
Figure
6-2).
T
B
I M I N G
E L T
Sections 6.4.1
Figure
5-3).
Figure
5-4).
A
D J U S TM E N T
through
6.4.3.
5-3).
Figure
5-3).
6-5
Advertisement
Table of Contents
