Table of Contents
Advertisement
3 .
P R O J E C T O R I N S T A L L A T I O N A N D
A S S E M B L Y
3.1.
U
N P A C K I N G T H E
Before opening box (es), carefully inspect outside of carton(s). If carton
has been damaged, notify shipper immediately; do not open carton
unless instructed to do so.
The CHRISTIE P35GPS projector may be shipped in more than one container. Each
P35GPS projector normally comes complete with the following items:
• dual aperture plate (shipped in place)
•
framing lamp (installed)
•
sound-head flywheel (not installed)
•
sound-head assembly (factory-aligned)
•
dual-lens turret
• drive motor assembly
• instruction manual.
The console and projector are shipped in a single carton, with special pockets containing
smaller items. The lens turret and sound-head flywheel are shipped separately.
To unpack:
1. Open carton(s).
2. Remove all protective material from framing lamp, sound-head assembly, and lens
holder.
3. Remove protective material around side panel.
3.2.
I
N S T A L L A T I O N
To install the projector, refer to Figure 3-1. The required materials and tools for installing
and assembling the P35GPS projector are outlined in the Table in Figure 3-2.
1. Loosen but do not remove nut on projector mounting stud (item 4 in Figure 3-1). Verify
that lock washer (item 5 in Figure 3-1) and flat washer (item 6 in Figure 3-1) are
correctly positioned on mounting stud. Flat washer should be next to lock washer,
followed by nut.
CHRISTIE DIGITAL SYSTEMS P35GPS Projector
March, 2004
3-1
P
R O J E C T O R
3
Advertisement
Table of Contents
