2: Installation And Setup; Projector Quick Setup And Installation - Christie Mirage M Series Setup Manual

2 Installation and Setup
2.1

Projector Quick Setup and Installation

The following instructions are for those preferring a quick setup. Refer to the remaining subsections for
detailed setup instructions.
STEP 1 - Installing a Projection Lens
The projection lens, shipped separately from the projector, must be installed prior to setting up the projector.
IMPORTANT!
LENS INSTALLATION
IMPORTANT!
1. Rotate the lens clamp to the OPEN position, see
Mirage M Series Setup Guide
020-100592-02 Rev. 1 (11-2010)
Always power down the projector and disconnect all power sources before servicing or
cleaning.
Refer to Safety Warnings and Guidelines in
Remove the lens plug from the lens opening in the projector before installing the lens.
Retain the lens plug for projector transportation to protect the projector's optical
components from dust and debris.
The lens seals the projector, preventing contaminants from entering the interior of the
projector. Never operate a projector without a lens.
Remove the rear lens cap from the lens. Keep the front lens cap on the lens to protect it
during installation.
F 2-1 L
IGURE
Section 4 Maintenance
Figure 2-1.
C O
OCKING LAMP PEN
.
2-1