Yamaha FZ6-ST Supplementary Service Manual page 99

Right handlebar switch lead
1
Rear brake light switch lead
2
Neutral switch lead
3
Fuel tank breather hose
4
Crankshaft position sensor lead
5
A Pass the right handlebar switch lead through the
hole located on the right side of the frame.
B Route the right handlebar switch lead under the
bracket 2.
C Route the coolant reservoir tank hose under the
cover 2. Route the radiator hose (outside) inner
side.
CABLE ROUTING
D Route the radiator hoses (2 pieces) under the cover
2.
E Route the crank shaft position sensor lead inner
side of the radiator hose.
F Pull down the mark-painted sections of the fuel tank
breather hose, fuel tank drain hose and coolant res-
ervoir tank breather hose to be lower than the clamp
position of the muffler stay. Any order to take out the
fuel tank breather hose and fuel tank drain hose can
be accepted.
G Pass the fuel tank breather hose, fuel tank drain
hose, coolant reservoir tank breather hose and
brake right switch lead through the guide of the stay
assembly 2.
H Clamp the tail brake light switch lead together with
the brake fluid fluid reservoir hose.
2-38
SPEC