Installing The Front Wheel - Yamaha FZ6-ST Supplementary Service Manual

FRONT WHEEL AND BRAKE DISCS
3. Measure:
4. Adjust:
a. Remove the brake disc.
b. Rotate the brake disc by one bolt hole.
c. Install the brake disc.
NOTE:
Tighten the brake disc bolts in stages and in a
crisscross pattern.
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment
f. If the brake disc deflection cannot be brought
EAS00545

INSTALLING THE FRONT WHEEL

The following procedure applies to both brake
discs.
1. Lubricate:
2. Lift the wheel up between the fork legs.
4-6
S brake disc thickness
Measure the brake disc thickness at a few
different locations.
Out of specification ! Replace.
Brake disc thickness limit
(minimum)
Front: 4.5 mm (0.18 in)
Rear: 4.5 mm (0.18 in)
S brake disc deflection
Brake disc bolt
18 Nm (1.8 mSkg, 13 ftSlb)

LOCTITE
steps until the brake disc deflection is within
specification.
within specification, replace the brake disc.
S wheel axle
S oil seal lips
Recommended lubricant
Lithium-soap-based grease
CHAS