Yamaha FZ6-ST Supplementary Service Manual page 12

Route the throttle cables above the stay assy 1.
Route the main switch lead above the clutch
cable.
Line up the left handlebar switch lead coupler
and fan motor lead coupler behind the head
pipe.
Route the clutch cable over the wire harness.
To the main switch.
Place three couplers on the flange of the cover.
To the fuel pump.
Clamp four wire leads. There should be no
excessive slack on the wire leads.
To the engine.
To the fuel tank.
Either installation position can be accepted, but
make sure that the leads are not crossed.
CABLE ROUTING
Clamp the rear turn signal light lead and license
plate light lead to the frame. Hook the clamp to
the bracket. Pull out the lead sufficiently to the
frame side and route it along with the side of the
back stay. Cut the tip of the clamp to be between
1 and 5 mm (0.04 and 0.20 in) upward.
Clamp the rear turn signal light lead and license
plate light lead to the frame. Cut the tip of the
clamp to be between 1 and 5 mm (0.04 and 0.20
in).
Gap between the lead and muffler should be 10
mm (0.39 in) or more.
Coupler should not run on the relay assembly.
To the tail/brake light.
To the license plate light.
To the rear turn signal light. (right)
6
SPEC