Yamaha FZ6-ST Supplementary Service Manual page 16

Point the tip of the clamp to the outside of the
vehicle.
Insert the enwinding clamp of the wire harness
into the hole of the rear frame.
Attach the rectifier/regulator lead to the clamp of
the rectifier bracket.
To the engine ground.
To the fuel injection.
To the fuel pump.
Route the clutch cable under the fuel injection
lead.
Pass the clutch cables through the clamp, and
then install the clamp to the cover. Position of
the clamp is forward of the cable stopper.
To the main switch.
CABLE ROUTING
Plate the adjuster of the clutch cable above
the cover.
Route the starter relay lead outside of the
main switch.
Press the battery negative lead into the space
between the ribs of the frame.
After connecting the coupler of the connector
cover position it inside.
Pass the spark plug leads #1 and #4 through
the slit of the cover 2.
Pass the spark plug lead #2 through the inner
hole of the cover 2.
Pass the spark plug lead #3 through the outer
hole of the cover 2.
Route the spark plug lead #4 behind the air
cut-off valve hose.
10
SPEC