Yamaha FZ6-ST Supplementary Service Manual page 237

HANDLEBAR
5. Install:
S grip end
6. Adjust:
S throttle cable free play
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" in chapter 3.
Throttle cable free play (at the
flange of the throttle grip)
3 X 5 mm (0.12 X 0.20 in)
7. Install:
S clutch lever holder 1
S clutch cable
NOTE:
Align the slit on the clutch lever holder with the
punch mark a on the handlebar.
8. Adjust:
S clutch cable free play
Refer to "ADJUST THE CLUTCH CABLE
FREE PLAY" in chapter 3.
Clutch cable free play (at the end
of the clutch lever)
10 X 15 mm (0.39 X 0.59 in)
9. Install:
S left handlebar switch
NOTE:
Align the projection a on the left handlebar
switch with the hole b on the handlebar.
10. Install:
S handlebar grip
S grip end
a. Apply a thin coat of rubber adhesive onto the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
4-58
CHAS
26 Nm (2.6 mSkg, 19 ftSlb)
26 Nm (2.6 mSkg, 19 ftSlb)