Yamaha FZ6-ST Supplementary Service Manual page 102

A Route the throttle cables above the stay assy 1.
B Route the main switch lead above the clutch cable.
C Line up the left handlebar switch lead coupler and
fan motor lead coupler behind the head pipe.
D To the main switch.
E Place three couplers on the flange of the cover.
F To the fuel pump.
G Clamp four wire leads. There should be no exces-
sive slack on the wire leads.
H To the engine.
I To the fuel tank.
J Either installation position can be accepted, but
make sure that the leads are not crossed.
CABLE ROUTING
K Clamp the rear turn signal lead and license plate
light lead to the frame. Hook the clamp to the brack-
et. Pull out the lead sufficiently to the frame side and
route it along with the side of the back stay. Cut the
tip of the clamp to be between 1 and 5 mm (0.04 and
0.20 in) upward.
L Clamp the rear turn signal lead and license plate
light lead to the frame. Cut the tip of the clamp to be
between 1 and 5 mm (0.04 and 0.20 in).
M Gap between the lead and muffler should be 10 mm
(0.39 in) or more.
N Coupler should not run on the relay assembly.
O To the tail/brake light.
P To the license plate light.
Q To the rear turn signal light. (right)
2-41
SPEC