Yamaha FZ6-ST Supplementary Service Manual page 319

CRANKCASE
NOTE:
Do not allow any sealant to come into contact
with the oil gallery or crankshaft journal bear-
ings. Do not apply sealant to within 2 X 3 mm of
the crankshaft journal bearings.
3. Install:
S dowel pin
4. Set the shift drum assembly and transmis-
sion gears in the neutral position.
5. Install:
S lower crankcase 1
(onto the upper crankcase 2 )
CAUTION:
Before tightening the crankcase bolts, make
sure that the transmission gears shift cor-
rectly when the shift drum assembly is
turned by hand.
6. Install:
S crankcase bolts
NOTE:
S Lubricate the bolt threads with engine oil.
S Install a washer on bolts 1 X
S Seal bolt
18
S Tighten the bolts in the tightening sequence
cast on the crankcase.
85 mm (3.3 in) bolts: 1 X 7 ,
M8
M8 115 mm (4.5 in) bolts: 8 , 9
M8 65 mm (2.6 in) bolts:
M6 65 mm (2.6 in) bolts:
M6 55 mm (2.2 in) bolts:
M6 45 mm (1.8 in) bolts:
M6 65 mm (2.6 in) bolts:
M6 75 mm (3.0 in) bolt:
M6 100 mm (3.9 in) bolt:
Crankcase bolt
Bolt 1 X
1st: 12 Nm (1.2 mSkg, 8.7 ftSlb)
2nd: 25 Nm (2.5 mSkg, 18 ftSlb)
*3rd: 27 Nm (2.7 mSkg, 20 ftSlb)
Bolt
24 Nm (2.4 mSkg, 17 ftSlb)
Bolt
14 Nm (1.4 mSkg, 1.0 ftSlb)
Bolt
12 Nm (1.2 mSkg, 8.7 ftSlb)
* Loosen the bolts following the tightening order
and then tighten to specification torque.
5-66
ENG
10 .
10
,
11 12
,
13 14
X
,
15 22 26
, ,
16 19 20
,
17 27
18
21
10
11 , 12
13 , 14
X
15 27