Yamaha FZ6-ST Supplementary Service Manual page 302

CLUTCH
EAS00276
REMOVING THE CLUTCH
1. Remove:
S clutch cable holder 1
S clutch cover 2
S gasket
NOTE:
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern.
After all of the bolts are fully loosened, remove
them.
2. Remove:
S compression spring bolts 1
S compression springs
S pressure plate 2
S pull rod 3
S friction plates
S clutch plates
3. Straighten the lock washer tab.
4. Loosen:
S clutch boss nut 1
NOTE:
While holding the clutch boss 2 with the univer-
sal clutch holder, loosen the clutch boss nut.
Universal clutch holder
90890-04086, YM-91042
5. Remove:
S clutch boss nut 1
S lock washer 2
S clutch boss 3
S thrust plate 4
EAS00280
CHECKING THE FRICTION PLATES
The following procedure applies to all of the fric-
tion plates.
1. Check:
S friction plate
Damage/wear ! Replace the friction plates
as a set.
5-49
ENG