Yamaha FZ6-ST Supplementary Service Manual page 342

CRANKSHAFT
c. Install the crankshaft journal upper bearings
1 and the crankshaft into the upper crank-
case.
NOTE:
Align the projections a on the crankshaft jour-
nal upper bearings with the notches b in the up-
per crankcase.
d. Put a piece of Plastigauge
crankshaft journal.
NOTE:
Do not put the Plastigauge
the crankshaft journal.
e. Install the crankshaft journal lower bearings
1 into the lower crankcase and assemble
the crankcase halves.
NOTE:
S Align the projections a of the crankshaft jour-
nal lower bearings with the notches b in the
lower crankcase.
S Do not move the crankshaft until the clearance
measurement has been completed.
f. Tighten the bolts to specification in the tight-
ening sequence cast on the crankcase.
Crankcase bolt
Bolt 1 X
1st: 12 Nm (1.2 mSkg, 8.7 ftSlb)
2nd: 25 Nm (2.5 mSkg, 18 ftSlb)
*3rd: 27 Nm (2.7 mSkg, 20 ftSlb)
Bolt
24 Nm (2.4 mSkg, 17 ftSlb)
Bolt
14 Nm (1.4 mSkg, 1.0 ftSlb)
Bolt
12 Nm (1.2 mSkg, 8.7 ftSlb)
* Loosen the bolts following the tightening order
and then tighten to specification torque.
NOTE:
Lubricate the crankcase bolt threads with en-
gine oil.
Refer to "CRANKCASE".
5-89
ENG

2 on each

over the oil hole in
10
11 , 12
13 , 14
X
15 27