Table of Contents
Advertisement
Table 5-7 describes the IP address and subnet mask settings.
Parameter
IP Address
Subnet Mask
Apply
Cancel
Click Apply to save the configurations. You can now configure other advanced
sections or start using the router (with the advanced settings in place).
Bridge mode
Figure 5-9 demonstrates how you can use the bridge mode. The router basically
becomes a hub/switch, allowing you to connect LAN clients to your Local Area
Network.
Table 5-7. Bridge mode parameters.
Type in an IP address for the bridge mode. This IP
address allows you to access the Web-based
management if you decide to switch back to the
router mode.
Type in the subnet mask for the bridge mode
management.
Click on this button to save your changes.
Click on this button to cancel your changes.
Figure 5-9. Bridge mode configuration.
CHAPTER 5: General Setup
Description
Switch/hub
49
Advertisement
Table of Contents
